9/14/2023 0 Comments Hp dock firmwareTry to set a system restore point before installing a device driver. It is highly recommended to always use the most recent driver version available. Pay attention to all installation instructions to make sure the driver is installed correctly If the setup requests Administrative rights, make sure to run the setup as Administrator Before installation, save all your work and close all the running programs, as the installation may interfere with other apps After the update is complete, undock and re-dock the notebook to enable the new firmware version. The status should display the message, "Action complete. Verify that the update was successfully completed by observing the status of the tool. Performing either of these actions may cause the DP hub to become unusable.ĥ. WARNING: Do not disconnect the notebook from the dock or remove the DP monitor during this process. The progress bars will indicate that the update process has started. After the DP monitor is enabled and powered on, double click the file to run the executable. Then make sure the monitor is enabled from the Windows Display Manager.Ĥ. Connect a monitor to the docking station DP port using the native DisplayPort or a DP-to-VGA adapter. Dock the notebook unit to the HP Ultraslim Docking Station.ģ. Download the file to a folder on your hard drive. Fixed the compatible issue with Philips 241P with AMD sourceġ. Fixed the no display issue after back from turn off display state with AMD source This package is provided for supported notebook models running a supported operating system. HP 2013 Ultraslim Docking Station DisplayPort Hub Firmware Update provides the EEPROM firmware required to enable the DisplayPort hub on the HP Ultraslim Docking Station.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |